origami

crane

step1:

Fold corner 1,2 near corner 3,4 then you open it. Now you fold corner 1,3 near corner 2,4 and then you open it again.

step2:

Now you should turn the paper.

step3:

Fold corner 2 near corner 3 and open him than, fold corner 1 near corner 4 and open him than.

step4:

Now you should turn the paper.

step5:

(place corner 3,4 for you)Get corner 2 at the point use the fold that you have made by step3 and now fold corner 2 with that fold him double and bring him near corner 4.

step6:

Fold corner 3 double and place him next the folded corner 2 and then push it flat.

step7:

Fold corner 5 near the diameter and do the same for corner 6.

step8:

Turn the paper around and do the same as step 7 if you have done it correectly it wil look like this.

step9:

Fold the two flaps open again.

step10:

Take the point with the circle and fold him open, keep your other hand down to the rest of the papers. Press corner 5 and 6 near the diameter.

step11:

You have to do the same with the other side if you have it correctly done it will look like this picture.

step12:

Fold corner 5 near the diameter do the same with corner 6.

step13:

Turn the paper around and do the same as step 12. If you have done it correctly it would like this.

step14

Fold the two dots near each other and do the same for the other side.

step15:

Fold the dot up and do the same for the other side.

step16:

Fold the two dots near each other and do the same for the other side.

step17:

Fold the two ends a little bit outside.

step18:

Make in one of the outside a had, by the top folding a little bid down and than pusch it.

step19:

At least fold the wings outside and pull slightly on it.

Not succeed? Watch this video and than I hope everything is clear.